Posté: Lun 12 Nov 2012, 14:59
salut, extrait sortie de la doc de durametric, en anglais, j'ai un peu de mal a comprendre 
, ne serai ce pas une cause de la non connection du logiciel duramétric sur certains cayenne 
, si un pro de l'anglais pouvait y jeter un oeil 
Common Problems and Solutions
Cannot reset the instrument cluster on 997, Cayman, Boxster (987)
Sometimes the instrument cluster does not accept the reset command. To clear the
instrument cluster remove the fuse for the instrument cluster after using the software to
reset the reminder. Simply removing the fuse will not clear the service reminder; it will
only reset the instrument cluster.
Cannot connect to 2005 – 2006 Cayenne
If the instrument cluster says “press brake pedal” this means the CAN network is asleep
and you need to wake up the network by pressing the brake pedal.
The CAN gateway may need to be reset. If VAG-Com has been used on this car it is
likely that the CAN gateway will need to be reset. To reset the CAN gateway take the key
out of the ignition and remove fuse #40 for at least 10 seconds. The fuse panel is on the
left side of the dashboard where the dashboard meets the door panel.
Receiving errors while running actual values
Start actual values with the car already running, do not start the car when actual values
are currently running as this resets the interface and may cause application errors.
, ne serai ce pas une cause de la non connection du logiciel duramétric sur certains cayenne , si un pro de l'anglais pouvait y jeter un oeil Common Problems and Solutions
Cannot reset the instrument cluster on 997, Cayman, Boxster (987)
Sometimes the instrument cluster does not accept the reset command. To clear the
instrument cluster remove the fuse for the instrument cluster after using the software to
reset the reminder. Simply removing the fuse will not clear the service reminder; it will
only reset the instrument cluster.
Cannot connect to 2005 – 2006 Cayenne
If the instrument cluster says “press brake pedal” this means the CAN network is asleep
and you need to wake up the network by pressing the brake pedal.
The CAN gateway may need to be reset. If VAG-Com has been used on this car it is
likely that the CAN gateway will need to be reset. To reset the CAN gateway take the key
out of the ignition and remove fuse #40 for at least 10 seconds. The fuse panel is on the
left side of the dashboard where the dashboard meets the door panel.
Receiving errors while running actual values
Start actual values with the car already running, do not start the car when actual values
are currently running as this resets the interface and may cause application errors.